Skip to main content
Daniel Russell
New Member
Nov 18, 2026 12:14 AM UTC
Question

Ellipse arc control is a pain

The arc tool currently requires you to use two coordinate systems. The start is an angle, the sweep is a percentage and the thickness (ratio? why is it called ratio?) is a percentage.

Why didn’t you just have a start, an end both in angle measurements (or both percentage being 1% = 3.6deg).

Also why did you decide a percentage for the thickness was a good idea? My guys, we deal in pixels. Is this because an ellipse can be oval shaped? Still think a pixel value would make a consistent experience. Or even better, let the user switch between them.

You’re just making us do maths that we shouldn’t really have a need to do. This should be a very simple set of controls.

1 reply

NorrisFByrd
New Participant
Nov 18, 2026 6:35 AM UTC

Completely agree — the mixed units are the worst part. I end up doing the maths in my head every time: sweep percentage times 360 to get the degrees, then guessing the thickness ratio against the actual pixel size. What I do now is rough the arc in by dragging first and only touch the numbers for the final tidy-up, holding Shift to snap in 45° steps. A straight pixel value for thickness, and start and end both in degrees, would make this a two-second job — especially for icons and progress rings.