Skip to main content
Answer

[Resolved] Publish error when linking to Supabase

  • November 18, 2025
  • 2 replies
  • 42 views
dum

Figma Make files with Supabase connections cannot be published to Community. 

 

[This post’s title was updated by a moderator from “Ошибка при публикование при связывание с Supabase” to “Publish error when linking to Supabase” on 19-Nov-2025.]

Best answer by Tom Reem

Hi ​@dum — thanks for your patience while this was being sorted out. I’ve been following the updates on this issue, and everything should now be working normally. You can go ahead and publish without running into that error.

If anything still feels off or you run into new behavior, feel free to reach back out. We’re here to help.

2 replies

Tom Reem
Figmate
  • Tom Reem
  • Figmate
  • November 19, 2025

Hello ​@dum — welcome to Figma Forum, and thanks for flagging this.

I checked on this, and there are a couple of factors likely contributing to what you’re seeing. There was a service interruption yesterday that may have affected publishing, and there’s also an active issue currently being worked through. You can follow updates on the Supabase status page: status.supabase.com.

Our engineering team is keeping a close eye on things and doing what we can to minimize any impact. Thanks for your patience while this gets sorted out — and please feel free to keep us posted if anything changes on your end.

Tom Reem
Figmate
  • Tom Reem
  • Figmate
  • Answer
  • November 23, 2025

Hi ​@dum — thanks for your patience while this was being sorted out. I’ve been following the updates on this issue, and everything should now be working normally. You can go ahead and publish without running into that error.

If anything still feels off or you run into new behavior, feel free to reach back out. We’re here to help.

Terms & ConditionsCookie settingsAccessibility statement